10 Pack Christmas Cracker Kit - An Enchanted Christmas

Kit includes:
10 x Double sided die cut cracker wrappers. Crackers can be made with either face facing outwards.
10 x Christmas Cracker snaps
10 x Cardboard reinforcements.

You will also need (not included): * Double sided tape or glue * Gifts or treats to fill * Ribbon of your choice

Size: Each completed cracker measures 37cm long x 6cm wide once completed. 

Instructions to make: 
1. Choose which design you wish to be on the outside of your cracker and lay on a table, with this side facing down.
2. Run a length of double sided tape on one long edge of the reverse side.
3. Lay a snap bang lengthwise in the center of the cracker. Use a little double sided tape to hold into place. (Note don't use too much tape otherwise they will not snap when pulled!)
4. Use double sided tape to attach a cardboard reinforcement, butted to the long edge opposite your double sided tape, and centered inside of the cut-outs. It should stop before it hits your double sided tape, and not overlap the cut-outs.
5. Peel the double sided tape and roll the cracker adhering the tape. Use your fingers to sharpen the paper around the cardboard insert.
6. Close one end with a ribbon bow.
7. Fill the cracker with your treats and seal the other end with ribbon ready for Christmas!